To install a second IDE drive into a computer, you must?

(A) Set the master-slave jumper to slave on the second drive

(B) Use the IDE configuration software to set the new drive as slave

(C) Verify that you define the new drive as D: in the CMOS setup

(D) Verity that you attach the drive to the connector at the end of the ribbon cable

Share:

Note: if you think the answer of the question is wrong or changed with time, Comment below with right answer or its better to contact us via “Contact us page” for quick update. We will really appreciate your contribution.

Comments:

Leave a Comment

Your email address will not be published. Required fields are marked *